LightBurn

Overview

This page needs a lot of work, so right now it's just a dumping ground for my notes. I'll work to improve it, or you can too.

Details

• Can open SVG
• Middle button scroll
• cut image

• adjusted laser position on the panel
• Upload
• Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser.
• Can choose "output" to only cut certain portions
• Upload failed - run "frame" to get reinitiate

• Fill + line: power/speed controls fill and then enables another line section

• If you can get it to "frame" but you click start and it just beeps at you, make sure you have some output chosen. (Image below)
• If you get "no object selected" or some other item, there is a different check mark (image below)