LightBurn

• Can open SVG
• Middle button scroll
• cut image

• adjusted laser position on the panel
• Upload
• Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser.
• Can choose "output" to only cut certain portions

• 3mm acrylic (speed/power)
  • cut 15/80
  • engrave
    • 100/20 - not enough to make it through paper
    • 60/40 too deep
    • 50/20 - also no good. barely touches it.
    • 50/30 - pretty deep, but clear that 30 is close to min power.