Revision as of 00:57, 24 September 2020

Overview

This page needs a lot of work, so right now it's just a dumping ground for my notes. I'll work to improve it, or you can too.

adjusted laser position on the panel
Upload
Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser.
Can choose "output" to only cut certain portions
Upload failed - run "frame" to get reinitiate

If you can get it to "frame" but you click start and it just beeps at you, make sure you have some output chosen. (Image below)
If you get "no object selected" or some other item, there is a different check mark (image below)

@@ Line 1: / Line 1: @@
+= Overview =
+This page needs a lot of work, so right now it's just a dumping ground for my notes.  I'll work to improve it, or you can too.
+= Details =
 * Can open SVG
@@ Line 12: / Line 18: @@
 * Fill + line:  power/speed controls fill and then enables another line section
-* If you can get it to "frame" but you click start and it just beeps at you, make sure you have some output chosen.  (Image coming)
+* If you can get it to "frame" but you click start and it just beeps at you, make sure you have some output chosen.  (Image below)
-* If you get "no object selected" or some other item, there is a different check mark (image coming)
+* If you get "no object selected" or some other item, there is a different check mark (image below)
+[[File:lightburn-screen.jpg|500px]]
 [[Category:Laser]]