Draw Bot: Difference between revisions
Jump to navigation
Jump to search
(→Links) |
(→Links) |
||
| Line 20: | Line 20: | ||
* [http://hektor.ch/ Hector] -- the inspiration for DK | * [http://hektor.ch/ Hector] -- the inspiration for DK | ||
* [http://www.gatesmectrol.com/mectrol/brochure.cfm?brochure=5199&location_id=4947 Gates Mectrol] -- possible source for the Polyurethane (PU) timing belts (aka linear motion belt) | * [http://www.gatesmectrol.com/mectrol/brochure.cfm?brochure=5199&location_id=4947 Gates Mectrol] -- possible source for the Polyurethane (PU) timing belts (aka linear motion belt) | ||
Revision as of 15:38, 20 September 2011
Bill of Materials
- Chassis/pen holder
- custom part, will need to build in house
- 2 x suction cups (mount points for belts)
- 2 x stepper drivers
- H Bridge power control TI 1320
- 2 x stepper motors
- go w/ 5mm shaft
- need 40ish oz/in?
- 2 x toothed belt pulleys
- go w/ 5mm shaft
- 20 ft toothed belt
- 7959521 -- Trapezoidal-Tooth Neoprene Belting Mxl Trade Size, .080" Pitch, 1/4" Width -- $1.84/foot
- 1 x servo (for controlling pen?)
- 1 x Arduino
Links
- Der Kritzler
- Hector -- the inspiration for DK
- Gates Mectrol -- possible source for the Polyurethane (PU) timing belts (aka linear motion belt)