Ultimaker: Difference between revisions
Jump to navigation
Jump to search
en>Rrix (Add upkeep) |
en>Rrix (Re-up the machine) |
||
| Line 1: | Line 1: | ||
'''The Ultimaker is | '''The Ultimaker is running, pending upkeep by [[User:Rrix]] and Colin.''' | ||
== Basics == | == Basics == | ||
| Line 16: | Line 16: | ||
== Upkeep Log == | == Upkeep Log == | ||
=== 30 November 2012 === | |||
* New PEEK tube turned on Lathe by colin | |||
* Colin installed the Makerbot mk6 extruder drive | |||
* Prints back up to installed quality. | |||
=== 14 November 2012 === | === 14 November 2012 === | ||
* Machine down pending new PEEK from Colin and Jake | * Machine down pending new PEEK from Colin and Jake | ||
Revision as of 23:10, 29 November 2012
The Ultimaker is running, pending upkeep by User:Rrix and Colin.
Basics
Take a look at our Ultimaker Quickstart Guide for your five minute crash course on the Ultimaker 3D printer.
Future Plans
I'd love to work on this awesome cassette extruder, but don't want to take the machine down until the Fakerbot is working better.
Tasks
- Clean bearings
- Build and install a hagen extruder
- Print Ultibarley in various colors to display the reels of colors we have available (Seriously)
Upkeep Log
30 November 2012
- New PEEK tube turned on Lathe by colin
- Colin installed the Makerbot mk6 extruder drive
- Prints back up to installed quality.
14 November 2012
- Machine down pending new PEEK from Colin and Jake
18 October 2012
- Set up remote gcode generation through dropbox (contact User:Rrix)
12 October 2012
- Flashed Marlin Rev2.0 on to machine
- Set up RepetierHost for GCode generation