LightBurn: Difference between revisions

From HeatSync Labs Wiki
Jump to navigation Jump to search
VisualWikitext
en>Gamebofh
No edit summary
en>Gamebofh
(remove power material stuff since it's in the material page now)
Line 11: Line 11:


* Fill + line:  power/speed controls fill and then enables another line section
* Fill + line:  power/speed controls fill and then enables another line section
* 3mm acrylic (speed/power)
** cut 15/80
** engrave
***100/20  - not enough to make it through paper
***60/40 too deep
***50/20 - also no good.  barely touches it.
***50/30 - pretty deep, but clear that 30 is close to min power.




[[Category:Laser]]
[[Category:Laser]]

Revision as of 18:32, 27 June 2020

  • Can open SVG
  • Middle button scroll
  • cut image
  • adjusted laser position on the panel
  • Upload
  • Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser.
  • Can choose "output" to only cut certain portions
  • Upload failed - run "frame" to get reinitiate
  • Fill + line: power/speed controls fill and then enables another line section
Retrieved from "https://heatsynclabs.wiki:443/index.php?title=LightBurn&oldid=2830"