LightBurn: Difference between revisions
Jump to navigation
Jump to search
en>Gamebofh No edit summary |
en>Gamebofh No edit summary |
||
| Line 8: | Line 8: | ||
* Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser. | * Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser. | ||
* Can choose "output" to only cut certain portions | * Can choose "output" to only cut certain portions | ||
* Upload failed - run "frame" to get reinitiate | |||
* Fill + line: power/speed controls fill and then enables another line section | |||
Revision as of 21:09, 20 June 2020
- Can open SVG
- Middle button scroll
- cut image
- adjusted laser position on the panel
- Upload
- Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser.
- Can choose "output" to only cut certain portions
- Upload failed - run "frame" to get reinitiate
- Fill + line: power/speed controls fill and then enables another line section
- 3mm acrylic (speed/power)
- cut 15/80
- engrave
- 100/20 - not enough to make it through paper
- 60/40 too deep
- 50/20 - also no good. barely touches it.
- 50/30 - pretty deep, but clear that 30 is close to min power.