LightBurn: Difference between revisions
Jump to navigation
Jump to search
en>Gamebofh No edit summary |
en>Gamebofh No edit summary |
||
| Line 16: | Line 16: | ||
***60/40 too deep | ***60/40 too deep | ||
***50/20 - also no good. barely touches it. | ***50/20 - also no good. barely touches it. | ||
***50/30 - pretty deep, but clear that 30 is close to min power. | |||
[[Category:Laser]] | [[Category:Laser]] | ||
Revision as of 21:02, 20 June 2020
- Can open SVG
- Middle button scroll
- cut image
- adjusted laser position on the panel
- Upload
- Start -says "Send the current design to the laser" in the tool tip, but it really means, start the laser.
- Can choose "output" to only cut certain portions
- 3mm acrylic (speed/power)
- cut 15/80
- engrave
- 100/20 - not enough to make it through paper
- 60/40 too deep
- 50/20 - also no good. barely touches it.
- 50/30 - pretty deep, but clear that 30 is close to min power.