Draw Bot: Difference between revisions
Jump to navigation
Jump to search
en>ScottyB (→Links) |
|||
| Line 19: | Line 19: | ||
* [http://tinkerlog.com/2011/09/02/der-kritzler/ Der Kritzler] | * [http://tinkerlog.com/2011/09/02/der-kritzler/ Der Kritzler] | ||
** [https://github.com/tinkerlog/Kritzler source] | ** [https://github.com/tinkerlog/Kritzler source] | ||
* [http://makezine.com/makeitlast/ Project3, Drawbot] Uses monofillament | |||
* [http://hektor.ch/ Hector] -- the inspiration for DK | * [http://hektor.ch/ Hector] -- the inspiration for DK | ||
* [http://www.gatesmectrol.com/mectrol/brochure.cfm?brochure=5199&location_id=4947 Gates Mectrol] -- possible source for the Polyurethane (PU) timing belts (aka linear motion belt) | * [http://www.gatesmectrol.com/mectrol/brochure.cfm?brochure=5199&location_id=4947 Gates Mectrol] -- possible source for the Polyurethane (PU) timing belts (aka linear motion belt) | ||
Revision as of 19:29, 20 September 2011
Bill of Materials
- Chassis/pen holder
- custom part, will need to build in house
- 2 x suction cups (mount points for belts)
- 2 x stepper drivers
- H Bridge power control TI 1320
- 2 x stepper motors
- go w/ 5mm shaft
- need 40ish oz/in?
- 2 x toothed belt pulleys
- go w/ 5mm shaft
- 20 ft toothed belt
- 7959521 -- Trapezoidal-Tooth Neoprene Belting Mxl Trade Size, .080" Pitch, 1/4" Width -- $1.84/foot
- 1 x servo (for controlling pen?)
- 1 x Arduino
Links
- Der Kritzler
- Project3, Drawbot Uses monofillament
- Hector -- the inspiration for DK
- Gates Mectrol -- possible source for the Polyurethane (PU) timing belts (aka linear motion belt)